top of page
  • mcfixit86

Rapsberry Pi 3 Remove Black Border for TV

Need to fill your screen and remove that black border on your TV? Then you need to try this method!

Raspberry Pi 3 kit -

Open Terminal: Alt+Control+T

Remove # from #disable_overscan=1

Then change the 1 to a 0.

It should look like this: disable_overscan=0

Next, scroll down and change the Overscan by removing the # and changing the numbers to this:





Exit by pressing Control+X

Press Y to save

Then press Enter

Reboot system... now you have a full screen for your TV!

Check out my website at

Note: if you still are showing a black border or missing some of the screen. Change the numbers up and down depending on what you need! The lower (or negative) a number is the bigger the displayed area will be. The higher (or positive) a number is the smaller the displayed area will be.

Thanks for watching! Like and subscribe!

Disclaimer: Due to factors beyond the control of MC FIX IT, I cannot guarantee against improper use or unauthorized modifications of this information in the video, post, blog, or social media. MC FIX IT assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. If you feel uncomfortable at any time. Stop and go to a professional. MC FIX IT recommends safe practices when working on vehicles, your house, or any other project and or with tools seen or implied in this video. Due to factors beyond the control of MC FIX IT, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not MC FIX IT.


bottom of page